![]() |
Routines |
| Prev: E289 | Up: Map | Next: E2A6 |
|
The first pass of the flat-piece blitter blit_flat_step comes here when flat_step_clip has patched the JR at the top of its loop to offset $33 (the piece's column is $1C or $1D, that is, it begins just left of the play area, whose columns are 1 to 28). It keeps the column saved for the next piece (column_address) in the right character row, moves L to column 1 of the row, and patches the loop's JR again (offset $4C) so that every later pair of rows goes straight to flat_blit_left_rows's second instruction. Then it skips the graphic's first byte, and through the JR flat_step_clip also patched (0 or 1) maybe a second one, so that only the bytes that lie on the play area are drawn.
Column $1D leaves two bytes of each row to draw (flat_blit_left_two_rows), column $1C one (flat_blit_left_one_row). The POPs that follow are one byte out of step with the graphic's pairs, which is why each row's last write and the drops in those two routines look lopsided.
|
||||||||||
| flat_blit_left_edge | E28E | INC A | Has the next piece's column come round to the start of a character row? | |||||||
| E28F | AND $1F | |||||||||
| E291 | JR NZ,flat_blit_left_edge_0 | |||||||||
| E293 | LD A,L | If so, take it back into this one | ||||||||
| E294 | SUB $20 | |||||||||
| E296 | LD (column_address),A | |||||||||
| flat_blit_left_edge_0 | E299 | LD A,L | L to column 1 of this pixel row | |||||||
| E29A | AND $E0 | |||||||||
| E29C | INC A | |||||||||
| E29D | LD L,A | |||||||||
|
This entry point is used by the routine at flat_blit_lose_first.
|
||||||||||
| flat_blit_left_edge_1 | E29E | LD A,$4C | From now on the loop's JR goes to flat_blit_left_rows + 1 (offset $4C) | |||||||
| E2A0 | LD ($E25A),A | |||||||||
| E2A3 | INC SP | Skip the graphic's first byte | ||||||||
| flat_blit_left_edge_2 | E2A4 | JR flat_blit_left_edge_2 | JR patched by flat_step_clip: 0 skips a second byte at flat_blit_left_rows, 1 does not | |||||||
| Prev: E289 | Up: Map | Next: E2A6 |